Pickup currently not available
The Garvee wheelchair ramp consists of two separately positionable aluminium rails and is designed for suitable steps, door thresholds, kerbs and similar height transitions.
Each ramp rail can be extended telescopically up to 1.83 m. After use, the two rails can be pushed back together and transported in the included carrying bag or stored more compactly.
The telescopic rails can be extended up to 1.83 m and adapted to different suitable steps, thresholds and kerb edges.
According to the product information, the pair of ramps can support loads of up to 272 kg and is intended for suitable wheelchairs, scooters and similar mobility aids.
After use, both aluminum rails can be pushed together and stored together in the supplied carrying bag.
The two ramp rails can be extended independently of each other and then adjusted to the same required length.
The ramps are designed for use with height differences of approximately 21.3 to 53.3 cm. However, height is not the only crucial factor: the actual ramp length, the available space, and the resulting gradient must also be compatible with the mobility aid being used.
According to the product specifications, each of the two rails reaches a maximum length of up to 1.83 m.
Thanks to its telescopic design, the length can be adjusted to different operating situations. Both rails should be set to the same length and positioned parallel to each other before use.
The ramp rails are made of aluminum. A maximum load of up to 272 kg is specified for the pair of ramps used together.
Before use, the combined weight of the user and mobility aid, as well as the wheel width and track width, should be checked. The specified maximum load capacity must not be exceeded.
The driving surfaces have a structured, non-slip surface that supports contact between wheels and ramp rails.
However, the surface does not replace correct positioning. Both ramp rails must be aligned stably, parallel, and correctly matched to the track width of the mobility aid being used.
The upper part of the ramp rails has rubber pads that support contact with the respective contact surface.
Before driving on them, check that both ramps are fully and stably in place and cannot shift during use.
According to the product information, the telescopic rails have locking elements made of stainless steel.
After setting the desired length, the locks must be fully engaged before the ramps are loaded.
The two ramp rails can be used on suitable door thresholds, individual steps, kerb edges and similar height transitions.
Whether a particular location is suitable depends on factors such as height, ramp length, gradient, contact area, and available space. These factors should be checked before each use.
After use, the ramp rails can be telescopically pushed together for more compact storage.
According to the product information, a carrying case is included in the scope of delivery and makes it possible to transport or store both rails together.
| Brand | Garvee |
| Product type | Telescopic wheelchair ramp |
| Set contents | 2 ramp rails |
| Max. length | 1.83 m per ramp rail |
| Load capacity | Up to 272 kg |
| material | aluminum |
| surface | Slip-resistant |
| construction | Telescopic |
| Locks | stainless steel |
| Scope of delivery | With carrying bag |
Note: Before each use, check the ramp length, gradient, total weight, wheel width, and track gauge. Position both rails parallel on a firm and load-bearing surface, fully engage them, and ensure the locking mechanisms are engaged before driving onto the ramp. Do not exceed the specified maximum load capacity of 272 kg.